[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xylo-SDR] S3 ADC board

To: "Xylo-SDR Discussion" <xylo-sdr@lists.ae5k.us>
Subject: [Xylo-SDR] S3 ADC board
From: "Leon Heller" <leon.heller@bulldoghome.com>
Date: Mon, 2 Jan 2006 16:27:52 -0000
Delivered-to: xylo-sdr-ae5k.us@che.dreamhost.com
List-archive: </pipermail/xylo-sdr-ae5k.us>
List-help: <mailto:xylo-sdr-request@lists.ae5k.us?subject=help>
List-id: Xylo-SDR Discussion <xylo-sdr-ae5k.us>
List-post: <mailto:xylo-sdr@lists.ae5k.us>
List-subscribe: <http://lists.ae5k.us/listinfo.cgi/xylo-sdr-ae5k.us>, <mailto:xylo-sdr-request@lists.ae5k.us?subject=subscribe>
List-unsubscribe: <http://lists.ae5k.us/listinfo.cgi/xylo-sdr-ae5k.us>, <mailto:xylo-sdr-request@lists.ae5k.us?subject=unsubscribe>
Reply-to: Xylo-SDR Discussion <xylo-sdr@lists.ae5k.us>

I've just updated my schematic:

http://www.leonheller.com/adc2.pdf

You can also see what the PCB looks like so far:

http://www.leonheller.com/adc2.gif

I'm designing it as a three-layer board so that it may easily be made athome. The surface-mount stuff is on the bottom, a ground plane is on thetop, and wire links (red tracks) are on top of that. That way, I only haveto etch one side and make any necessary clearances around holes on the topground plane.


Regards,

Leon
--
Leon Heller, G1HSM
leon.heller@bulldoghome.com

http://www.geocities.com/leon_heller

Prev by Date: Re: [Xylo-SDR] Some design thoughts requested
Next by Date: Re: [Xylo-SDR] Some design thoughts requested
Previous by thread: [Xylo-SDR] S3 ADC schematic
Next by thread: [Xylo-SDR] S3 PCB routed
Index(es):
- Date
- Thread