[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xylo-SDR] FPGA board
What does the Eurocard standard calls for? I've looked up a lot of boards
lately and the schematic labels them 1-96
At 09:11 AM 1/16/2006, you wrote:
We need to decide on the
function of all 96 pins on the DIN41612
connector soon before you finalize your design.
A suggestion: The pins are normally numbered A1-A32, B1-B32, and
C1-C32. A1, B1, and C1 start on the same side of the connector.
Using pin numbering of 1-96 will cause more confusion.
On 1/16/06, Leon Heller <firstname.lastname@example.org> wrote:
> I've just ordered some FAN1112 1.2V regulators direct from
> seemed to have a problem with my credit card (I probably got the
> wrong) so I've cancelled that order. My Fairchild distributor had
> only if I wanted to buy a reel of 2,500! 1.2V regulators are
> difficult to find, probably because the output voltage is lower than
> reference supply used on most regulators.
> I've got some triple output switching regulator samples from TI that
> made specifically for FPGAs, but they are a lot harder to use.
> I've also ordered a couple of the SRAMs from Farnell.
> I've made the PCB 100 mm x 100 mm, and changed all the Rs and Cs to
> On the DIN41612 connector I'm using pins 1, 33 and 65 for Gnd and
> 64 and 96 for 5V. It's a four-layer board with a ground plane and
> voltage plane for VccIO (3.3V). I'll use a copper pour area for
> 73, Leon
> Leon Heller, G1HSM
> Xylo-SDR mailing list
> To post msg: Xylo-SDR@ae5k.us
> Subscription help:
> Xylo-SDR web page:
> Forum pages:
Xylo-SDR mailing list
To post msg: Xylo-SDR@ae5k.us
Xylo-SDR web page:
I fail to see why doing the same thing over and over and getting the
same results every time is insanity: I've almost proved it isn't; only a
few more tests now and I'm sure results will differ this time ...