Leon
BTW - IHMO the I2C connector on the front
panel AND buss is very important. Although we might have some noise problems,
there is just TOO MUCH we can do with I2C to ignore. It will allow us to
breadboard ‘out of enclosure’ stuff in the future and is only an
elegant 2 pin expense. Follow Xylo/Saxo pins for this.
Thanks – You ARE Truckin!
Eric
From:
xylo-sdr-bounces@lists.ae5k.us [mailto:xylo-sdr-bounces@lists.ae5k.us] On Behalf Of Eric Ellison
Sent: Monday, January 16, 2006
6:28 PM
To: 'Xylo-SDR Discussion'
Subject: Re: [Xylo-SDR] FPGA board
Folks
Guess I am few hours behind in my
responses and a dollar – euro short.
Eric
From:
xylo-sdr-bounces@lists.ae5k.us [mailto:xylo-sdr-bounces@lists.ae5k.us] On Behalf Of Leon Heller
Sent: Monday, January 16, 2006
11:09 AM
To: Xylo-SDR Discussion
Subject: Re: [Xylo-SDR] FPGA board
----- Original Message -----
Sent: Monday, January
16, 2006 3:45 PM
Subject: Re: [Xylo-SDR]
FPGA board
What does the Eurocard
standard calls for? I've looked up a lot of boards lately and the schematic
labels them 1-96
I've just changed them to A1 etc. Amended schematic has been uploaded.