Difference between revisions of "ANCILLARY"

From HPSDRwiki
Jump to: navigation, search
(Added N1UL's PDF file on low noise osc. design)
(Reorganized page, added Loop Antenna section)
Line 1: Line 1:
==ANCILLARY==
+
== LOOP ANTENNA ==
  
This is a wiki page which will be used to document ancillary equipment or "stuff" that may be useful to the general HPSDR project.
+
(more info and documentation coming here)
 +
 
 +
== MISCELLANEOUS STUFF ==
  
 
'''Good Reading Link'''
 
'''Good Reading Link'''
Line 24: Line 26:
 
http://hpsdr.org/downloads/GBPhaseNoiseAnalysis4-20-07.pdf
 
http://hpsdr.org/downloads/GBPhaseNoiseAnalysis4-20-07.pdf
  
'''Modified Norton Amp simulation using Infineon BFP 490'''
+
== MODIFIED NORTON AMP ==
 
+
This simulation agrees with my test-circuit within about 0.2dB
+
  
Depending on the transformer, (2+2)/2, inductance, this works from 1 MHZ to 1 GHz max. The IP3 of about 38 dBm is excellent, the NF about 2dB. The reverse isolation can be more then 60dB, and a push-pull version has reduced IP2.
+
Submitted by Ulrich Rohde, N1UL:
  
Have fun, 73 de Ulrich, N1UL
+
This simulation using the Infineon BFP490 agrees with my test-circuit within about 0.2dB. Depending on the transformer, (2+2)/2, inductance, this works from 1 MHZ to 1 GHz max. The IP3 of about 38 dBm is excellent, the NF about 2dB. The reverse isolation can be more then 60dB, and a push-pull version has reduced IP2.
  
 
Click on the "media" link below each drawing if you want a PDF file with slightly higher resolution.
 
Click on the "media" link below each drawing if you want a PDF file with slightly higher resolution.

Revision as of 18:38, 29 September 2007

LOOP ANTENNA

(more info and documentation coming here)

MISCELLANEOUS STUFF

Good Reading Link

GNU Radio has a nice page with a lot of good reference reading information on it. http://gnuradio.org/trac/wiki/SuggestedReading

Power Supply

Here's a link to one possible VERY SMALL power supply for the Atlas backplane: http://www.mini-box.com/s.nl/it.A/id.417/.f?sc=8&category=13

Please note that extensive testing has not been performed yet on this unit and as of this writing it is not in stock. The HPSDR group does not necessarily recommend this particular supply at this time.

HF Power Amplifiers

HFPROJECTS.com, operated by Virgil K5OOR, offers some interesting kits which might be suitable for HPSDR project transmitting when Phoenix or Penelope becomes available, or for other transmitters. The link is http://www.hfprojects.com/newsletter.htm Two current offerings are a "pre-amp" (PA-100) for boosting a HF signal from the 100 mw range to the 5 watt or greater region, to be able to drive the SUPERPACKER PRO solid state amplifier -- a 100 watt continuous duty beast! Be aware that this is NOT an open source project, and the one submitting this information has some serious reservations about the operation of the amplifier and the project.

A Novel Grounded Base Oscillator Design for VHF/UHF Frequencies

This is a PDF file submitted by Ulrich Rohde, N1UL, which can be downloaded (about 3 MBytes) from http://hpsdr.org/downloads/GBPhaseNoiseAnalysis4-20-07.pdf

MODIFIED NORTON AMP

Submitted by Ulrich Rohde, N1UL:

This simulation using the Infineon BFP490 agrees with my test-circuit within about 0.2dB. Depending on the transformer, (2+2)/2, inductance, this works from 1 MHZ to 1 GHz max. The IP3 of about 38 dBm is excellent, the NF about 2dB. The reverse isolation can be more then 60dB, and a push-pull version has reduced IP2.

Click on the "media" link below each drawing if you want a PDF file with slightly higher resolution.

Norton 2stage amp.jpg media:Norton 2stage amp2.pdf

Norton 2tone test.jpg media:Norton 2Tone test2.pdf

Norton sweep.jpg media:Norton Sweep2.pdf