Ahti
Ok, Ok, I'm on m, cm, mm now! Now if I could figure out what 37 C deg in
Australia is like, I'll be a metric convert! (smile)
Eric
-----Original Message-----
From: xylo-sdr-bounces@lists.ae5k.us [mailto:xylo-sdr-bounces@lists.ae5k.us]
On Behalf Of Ahti Aintila
Sent: Sunday, January 15, 2006 5:52 PM
To: Xylo-SDR Discussion
Subject: Re: [Xylo-SDR] Questions - Enclosure - MB - Kicad
> I don't mind 4", it'll give more room for tracks, which my board will
> have a
> lot of, and I might be able to make them 8 mils. 6 mil tracks don't
> cost any
> more than 8 mil ones, from most suppliers, though.
>
Leon,
If possible, keep it 8 mils or 0.2 mm. Many of the protoshops
(especially in the cheap East) charge more of the 0.15 mm tracks. Also
the yield will be better with wider tracks.
Ahti OH2RZ
PS: Several decades ago I saw one American engineer complaining in the
IEEE Spectrum that people are going inch by inch to the SI units of
measurements at the speed of furlong per fortnight. Seems to be true,
still! :-D
_______________________________________________
Xylo-SDR mailing list
To post msg: Xylo-SDR@ae5k.us
Subscription help: http://lists.ae5k.us/listinfo.cgi/xylo-sdr-ae5k.us
Xylo-SDR web page: http://xylo-sdr.ae5k.us
Forum pages: http://www.hamsdr.com/hamsdrforum/
_______________________________________________
Xylo-SDR mailing list
To post msg: Xylo-SDR@ae5k.us
Subscription help: http://lists.ae5k.us/listinfo.cgi/xylo-sdr-ae5k.us
Xylo-SDR web page: http://xylo-sdr.ae5k.us
Forum pages: http://www.hamsdr.com/hamsdrforum/