Difference between revisions of "Antenna Switch"

From HPSDRwiki
Jump to: navigation, search
(+cat)
(See Also: revised to show version 3 changes)
Line 13: Line 13:
 
[[Media:HPSDR FlachbandkabelVerbindung.pdf|Ribbon cable diagram]] (PDF)
 
[[Media:HPSDR FlachbandkabelVerbindung.pdf|Ribbon cable diagram]] (PDF)
  
[[Media:Antennenumschalter_V2_SBK.pdf‎|Schematic Diagram of Antenna Switch‎]] (PDF)
+
[[Media:AU V3 Schematic.sbk.pdf‎|Schematic Diagram of Antenna Switch‎]] (PDF)
  
[[Media:AntennenumschalterV2 BOM.pdf|Bill of materials‎]] (PDF)
+
[[Media:AU_V3_Dimensions.pdf|Mechanical layout of the Antenna Switch‎]] (PDF)
 
+
[[Media:Antennenumschalter_V2_BT.pdf|Mechanical layout of the Antenna Switch‎]] (PDF)
+
  
 
[[Category:Antenna switch| ]]
 
[[Category:Antenna switch| ]]

Revision as of 01:15, 19 March 2010

Photo of a version 2 Antenna Switch with an installed 6 meter Low Noise Amplifier (LNA)
Photo of W9KFB's installation in a Pandora box with Penelope, Ozy, and Mercury HPSDR boards

The Antenna Switch, made by NT Electronics, is designed to switch an antenna to the Mercury antenna BNC connector or to the Penelope BNC antenna connector. This function is included in the Alex filter board assembly, but for various reasons, many in the HPSDR community will opt to purchase a commercial amplifier that will operate with an input of up to 500 mw. Tokyo Hy-Power Labs makes compatible solid state amplifiers and some hams are using them with the HPSDR transceiver components developed and produced to date..

This HPSDR component was developed by Gerd, DJ8AY, who manufactures it currently. Ron, W9KFB is assisting Gerd to make it available to the global HPSDR community by listing it on eBay sites worldwide. You can find these listings by searching eBay for HPSDR components or by just searching for eBay Power Seller: red_ella on any eBay site.

See Also

Antenna Switch Use Instructions

Ribbon cable diagram (PDF)

Schematic Diagram of Antenna Switch‎ (PDF)

Mechanical layout of the Antenna Switch‎ (PDF)