Difference between revisions of "Apollo - Development Discussion"
From HPSDRwiki
Line 4: | Line 4: | ||
October 10, 2009 | October 10, 2009 | ||
− | The New PDF version of the schematic is here: [[media:Apollo_Schematic_rev_1A.pdf|PDF | + | The New PDF version of the schematic is here: [[media:Apollo_Schematic_rev_1A.pdf|PDF Rev 1A Schematic]]. |
+ | The Silkscreen Top here: [[media:Apollo_silk_top.pdf|Silkscreen Top, Rev 1A]]. | ||
+ | The Silkscreen Bottom is here: [[media:ApolloSilkBottom.pdf|Silkscreen Bottom, Rev 1A]]. | ||
+ | The PCB Top here: [[media:ApolloPCBTop.pdf|PCB Top, Rev 1A]]. | ||
+ | The PCB Bottom is here: [[media:ApolloPCBBottom.pdf|PCB Bottom, Rev 1A]]. | ||
+ | |||
+ | |||
+ | ---- | ||
Revision as of 09:36, 10 October 2009
The initial Apollo schematic is available for comment and suggestions are desired. Please place them here or email to the mailing list hpsdr@lists.openhpsdr.org or direct email to Kjell Karlsen
October 10, 2009
The New PDF version of the schematic is here: PDF Rev 1A Schematic.
The Silkscreen Top here: Silkscreen Top, Rev 1A. The Silkscreen Bottom is here: Silkscreen Bottom, Rev 1A.
The PCB Top here: PCB Top, Rev 1A. The PCB Bottom is here: PCB Bottom, Rev 1A.
The original PDF version of the schematic is here: PDF rev 0 Schematic.
Three comments:
- I believe the interface is SPI rather than I2C for the TPIC595 latches.
- 74HC14 can be used in lieu of 74HC04. The '14 has Schmitt trigger inputs, might help with noise immunity on the control line(s).
- Suggest considering PIN diode antenna switching instead of a relay (RL15). For those who operate CW QSK, quiet is nice. It's even nice for those who don't :-). KK7P 21:22, 14 June 2009 (UTC)
- Another comment: An Elecraft T-1 could also be accommodated at these power levels as an alternative to the suggested LDG. Disclaimer: I work for Elecraft. KK7P 05:02 31 July 2009 (UTC)