Difference between revisions of "Ghpsdr3 dspserver"
(New page: The dspserver program is used to separate the DSP components from the GUI components. dspserver accepts the following command on the command line. '''--receiver 0|1|2|3 (default 0)''' ...) |
|||
(One intermediate revision by the same user not shown) | |||
Line 17: | Line 17: | ||
'''--soundcard name (depends on your machine)''' | '''--soundcard name (depends on your machine)''' | ||
+ | <blockquote> | ||
+ | SANTA_CRUZ<br> | ||
+ | AUDIGY_2_ZS<br> | ||
+ | MP3_PLUS<br> | ||
+ | EXTIGY<br> | ||
+ | DELTA_44<br> | ||
+ | FIREBOX<br> | ||
+ | EDIROL_FA_66<br> | ||
+ | HPSDR<br> | ||
+ | UNDEFINED<br> | ||
+ | |||
+ | default HPSDR | ||
+ | </blockquote> | ||
'''--offset 0''' | '''--offset 0''' | ||
+ | <blockquote> | ||
+ | |||
+ | sets the I/Q offset. Needed for some cards such as some SoundBlaster | ||
+ | card where the samples are delayed by 1 sample between the 2 channels. | ||
+ | (i.e. --offset -1). | ||
+ | default (0) | ||
+ | </blockquote> | ||
[[Category:ghpsdr3 dspserver| ]] | [[Category:ghpsdr3 dspserver| ]] |
Latest revision as of 07:07, 6 September 2010
The dspserver program is used to separate the DSP components from the GUI components.
dspserver accepts the following command on the command line.
--receiver 0|1|2|3 (default 0)
receiver that this client is attached to (Please note singular). Also please not that receivers are 0 based.
--server 0.0.0.0 (default 127.0.0.1)
ip address of the server machine. Default is the localhost (127.0.0.1).
--soundcard name (depends on your machine)
SANTA_CRUZ
AUDIGY_2_ZS
MP3_PLUS
EXTIGY
DELTA_44
FIREBOX
EDIROL_FA_66
HPSDR
UNDEFINED
default HPSDR
--offset 0
sets the I/Q offset. Needed for some cards such as some SoundBlaster card where the samples are delayed by 1 sample between the 2 channels. (i.e. --offset -1).
default (0)