Difference between revisions of "Ghpsdr dspserver"
From HPSDRwiki
(New page: The dspserver program is used to separate the DSP components from the GUI components.) |
|||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
The dspserver program is used to separate the DSP components from the GUI components. | The dspserver program is used to separate the DSP components from the GUI components. | ||
+ | |||
+ | |||
+ | dspserver accepts the following command on the command line. | ||
+ | |||
+ | '''--receiver 0|1|2|3 (default 0)''' | ||
+ | |||
+ | <blockquote> | ||
+ | receiver that this client is attached to (Please note singular). Also please not that receivers are 0 based. | ||
+ | </blockquote> | ||
+ | |||
+ | '''--server 0.0.0.0 (default 127.0.0.1)''' | ||
+ | |||
+ | <blockquote> | ||
+ | ip address of the server machine. Default is the localhost (127.0.0.1). | ||
+ | </blockquote> | ||
+ | |||
+ | '''--soundcard name (depends on your machine)''' | ||
+ | |||
+ | '''--offset 0''' | ||
+ | |||
+ | |||
+ | [[Category:ghpsdr3 dspserver| ]] |
Latest revision as of 13:42, 5 September 2010
The dspserver program is used to separate the DSP components from the GUI components.
dspserver accepts the following command on the command line.
--receiver 0|1|2|3 (default 0)
receiver that this client is attached to (Please note singular). Also please not that receivers are 0 based.
--server 0.0.0.0 (default 127.0.0.1)
ip address of the server machine. Default is the localhost (127.0.0.1).
--soundcard name (depends on your machine)
--offset 0