[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xylo-SDR] Wolfson chip interface for S3 and Xylo

No virtual ground either, I think it's really needed to get most accurate readings, specially around the base band.

At 12:25 PM 12/26/2005, you wrote:
On 12/26/05, Leon Heller <leon.heller@bulldoghome.com> wrote:
> I've uploaded my S3 interface for the Wolfson chip to:
> http://www.geocities.com/leon_heller/adc2.pdf
> Comments, please.
> It's not quite complete, I need to add the op-amp -ve supply; I'll simply
> bias them at 2.5V, to keep things simple.
> I could easily convert it to a Xylo interface, if anyone is interested.
> 73, Leon

Isn't a TL082 a little too noisy for the ADC input amp? I think that
all these high performance ADCs are quite sensitive to the input amps
used as far as being able to approach the data sheet numbers.  I would
not stray too much from their data sheet recommendations.

Phil N8VB
Xylo-SDR mailing list
To post msg: Xylo-SDR@ae5k.us
Subscription help: http://lists.ae5k.us/listinfo.cgi/xylo-sdr-ae5k.us
Xylo-SDR web page: http://xylo-sdr.ae5k.us
Forum pages: http://www.hamsdr.com/hamsdrforum/

Cecil Bayona

"I fail to see why doing the same thing over and over and getting the same results every time is insanity: I've almost proved it isn't; only a few more tests now and I'm sure results will differ this time ... "