Re: [Xylo-SDR] Questions - Enclosure - MB - Kicad

[Philip Covington <p.covington@gmail.com>]

Also,  unlike the Xylo board, please use the FX2's 16 bit FIFO mode. 
The Xylo only uses the 8 bit interface mode which puts a limit on the
interface speed.

Phil N8VB


On 1/15/06, Leon Heller <leon.heller@bulldoghome.com> wrote:
> ----- Original Message -----
> From: "Eric Ellison" <ecellison@comcast.net>
> To: "'Xylo-SDR Discussion'" <xylo-sdr@lists.ae5k.us>
> Sent: Sunday, January 15, 2006 2:31 PM
> Subject: Re: [Xylo-SDR] Questions - Enclosure - MB - Kicad
>
>
> > Phil
> >
> > Thanks
> >
> > Designer Group: Be forwarned or speak your peace. Project board size is
> > now
> > 4"x4" with buss connector opposite 'external real-world connections'
> >
> > Leon - Don't forget some status leds and perhaps a PB (reset?).
>
> I was going to make my board 80 mm x 100 mm (half Eurocard). Should I change
> it to 4" x 4"?
>
> I'll include some LEDs.
>
> I've found that Farnell stocks the SRAM, I'll order a couple. I've created
> the part and added it to the design, but I'm not sure of the footprint (I
> guessed the pad sizes). I'll see if it is on the IPC site.
>
> 73, Leon
>
> _______________________________________________
> Xylo-SDR mailing list
> To post msg: Xylo-SDR@ae5k.us
> Subscription help: http://lists.ae5k.us/listinfo.cgi/xylo-sdr-ae5k.us
> Xylo-SDR web page: http://xylo-sdr.ae5k.us
> Forum pages: http://www.hamsdr.com/hamsdrforum/
>