[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xylo-SDR] Questions - Enclosure - MB - Kicad
----- Original Message -----
From: "Eric Ellison" <firstname.lastname@example.org>
To: "'Xylo-SDR Discussion'" <email@example.com>
Sent: Sunday, January 15, 2006 8:40 PM
Subject: Re: [Xylo-SDR] Questions - Enclosure - MB - Kicad
I'll sit back and listen to this discussion. It IS important. Also the
proposal on the floor is for a 100 x 100 mm board.
IMHO - This IS the 'heart' and sole of our project, and deserves a LOT of
thought. I'm for spending more $ on this component than any other. It
to be as versatile as we can afford. This is probably going to be a 1 off
(actually let's consider 25 off for this run for 'our' Xylo-Phreaks.) I
personally don't see $150 or more on this board as being objectionable. I
have already spent $250 on FPGA for fun stuff.
With Case, power, and your board, it actually could be an experimental
system we could sell for profit. I'm not suggesting that, but there are a
lot higher priced naked boards out there which are pretty but don't cut
mustard for an end product. What we produce will be our end product but
necessarily the rest of the world.
I was intending to sell the FPGA boards on their own, as it'll make a nice
general purpose board. The cost would be around $125, or less, depending on