[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xylo-SDR] Cases
I did a quick layout of four vertical DIN41612 96 pin connectors and
two right angle 96 pin connectors for inter-motherboard connectivity.
I was able to fit it within a motherboard footprint of 4"x4.25". One
of the right angle DIN41612 connectors could be used to apply power to
the motherboard and/or we can put a powerpole pcb connector on the
motherboard too.
This gives four slots per motherboard spaced 0.75" apart. The slots
(and the right angle inter-motherboard connectors) would not need to
be populated it you are not using them... cutting down on the cost in
some cases...
73 de Phil N8VB
On 1/6/06, Eric Ellison <ecellison@comcast.net> wrote:
>
>
>
> Folks
>
>
>
> Have been casting around looking at possible project cases for the MB
> housing and suggested 4"x2" form factor and have not found anything exactly
> what we want in aluminum. Should I branch out to plastic of some form
> polycarbonate or the like? Best fit are instrument, or meter enclosures, but
> they don't have the internal slides for PCB's.
>
>
>
> Thanks
>
> Eric
>
>
> _______________________________________________
> Xylo-SDR mailing list
> To post msg: Xylo-SDR@ae5k.us
> Subscription help:
> http://lists.ae5k.us/listinfo.cgi/xylo-sdr-ae5k.us
> Xylo-SDR web page: http://xylo-sdr.ae5k.us
> Forum pages: http://www.hamsdr.com/hamsdrforum/
>
>