[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xylo-SDR] Teamspeak FPGA discussion - Have we painted ourselves into a corner? Boxed ourselves in?
Leon will be pulling his hair out if we totally keep changing the
card.
PCI cards are very expensive, you have to cut the board to have the edge
connector. No cheap deals with PCI.
At 01:57 PM 1/21/2006, you wrote:
Folks
We had a long discussion regarding transporting intra board RF signals on
the feature connector side of the board.
Just for verbal clarification regarding the project enclosure: Designers
have ONLY ONE 100 mm edge for connections to the outside world.
Connections between boards can ONLY be done over the buss. The other
three sides are totally blocked by the enclosure and backplane.
Cecil, Bill and I did discuss possible options for board
interconnects NOT on the bus for RF or lvds sigs.
Dip header (perhaps 10 pin) for twisted pair lvds sigs mounted recessed
away from the front panel on the project board. Meaning they would not
protrude through the front panel.
The boards when slid into the enclosure, would be about 1/8? from the
front face of the enclosure, allowing RG-174 or twisted pair to pass from
board to board, along the front of the enclosure behind the aluminum
front panel.
It occurs to me that we really have ?boxed ourselves in? with our EuroBus
design. It seems that we really do need an RF bus and a slow speed buss,
to really make this a universal design.
Although we have spent a great deal of time discussing this, we don?t
have one penny invested yet.
I?m for going back to the PCI buss passive backplane design I originally
suggested. Drop the caboodle in an Aria (or whatever) enclosure with
power supply and have done with it. That way project designers have any
size board with suitable L-Bracket mounting. PCI is going to be
around for some time yet. Also we can use a ?twisted pair? IDC connector
or scsi cable at the rear of the boards for the high speed lvds stuff.
There is PLENTY of room in a mini-itx enclosure for crystal ovens and
other bulky things like 100 w PA?s etc. Fans for ventilation etc.
Plenty of prototyping board options. Plenty of leds on the front panel
etc.
Remember we are not at commit stage.
Comments?
Eric
_______________________________________________
Xylo-SDR mailing list
To post msg: Xylo-SDR@ae5k.us
Subscription help:
http://lists.ae5k.us/listinfo.cgi/xylo-sdr-ae5k.us
Xylo-SDR web page:
http://xylo-sdr.ae5k.us
Forum pages:
http://www.hamsdr.com/hamsdrforum/
Archives:
http://lists.ae5k.us/pipermail/xylo-sdr-ae5k.us/
Cecil Bayona
KD5NWA
www.qrpradio.com
"I fail to see why doing the same thing over and over and
getting the same results every time is insanity: I've almost proved it
isn't; only a few more tests now and I'm sure results will differ this
time ... "