Difference between revisions of "DOC"
(→Janus/Ozy: correct filename) |
|||
| Line 110: | Line 110: | ||
[[Image:Cover Rev2.1.jpg|thumbnail|left|[http://openhpsdr.org/wiki/images/c/cc/Janus_%26_Ozy_with_PowerSDR_v2-1.pdf Janus & Ozy with PowerSDR], ''Rev 2.1, September 2009''.]] | [[Image:Cover Rev2.1.jpg|thumbnail|left|[http://openhpsdr.org/wiki/images/c/cc/Janus_%26_Ozy_with_PowerSDR_v2-1.pdf Janus & Ozy with PowerSDR], ''Rev 2.1, September 2009''.]] | ||
| − | + | [http://openhpsdr.org/wiki/images/f/f6/Janus_%26_Ozy_with_PowerSDR_v2-1.pdf Janus & Ozy with PowerSDR, Rev 2.1], ''September 2009'' | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | [http://openhpsdr.org/wiki/images/f/f6/Janus_%26_Ozy_with_PowerSDR_v2- | + | |
This revision updates the DB-9 connector pin-out with an independent PTT on pin 8(valid from Ozy_Janus.rbf v1.6 onwards). | This revision updates the DB-9 connector pin-out with an independent PTT on pin 8(valid from Ozy_Janus.rbf v1.6 onwards). | ||
Revision as of 03:17, 25 September 2009
HPSDR Documentation
This newly created section will eventually contain links for downloading all documentation for HPSDR Projects.
Please bear with us as this area comes together.
More documentation and resources are available at Resources (Software links) and Support (Hardware documentation).
Atlas
Atlas Backplane , Rev 1.4, June 2006
This is the backplane into which all other board are pluged for power and communications.
Pinocchio
Pinocchio Extender Board, Rev 1.0, July 2006
This board allows the experimenter to extend the HPSDR board above the other boards so that measurments can be taken while the system is in use. Mainly used by board developers.
Penelope
Penelope with PowerSDR, Rev 1.2, May 2008
The manual describes how to physically set up Penelope as well as how to set up PowerSDR to use Penelope. Revision 1.1 contains corrections to the pin-out of the DB-25 connector (changed pin 7 to 17 as one of the analog grounds and added pin 21 as digital ground). Additionally we note that the current version of PowerSDR for Penelope contains a bug that, on start-up, will immediately make Penelope transmit in voice modes. A work-around to avoid this is described in Appendix A.
Revision 1.2 contains an additional section explaining why no Transmit Image Rejection is necessary and that therefore the corresponding Phase and Gain controls should both be set to zero.
Mercury
Mercury Operation with PowerSDR, Rev 1.0, January 2009.
This manual describes how to physically set up Mercury and how to set up PowerSDR to use Mercury.
Janus/Ozy
Janus & Ozy with PowerSDR, Rev 2.1, September 2009
This revision updates the DB-9 connector pin-out with an independent PTT on pin 8(valid from Ozy_Janus.rbf v1.6 onwards).
