Difference between revisions of "HPSDRwiki:Community Portal"
(Added the HL-45 intro) |
m (→The Tokyo HY-POWER HL-45 Solution: added "it") |
||
Line 39: | Line 39: | ||
== [[The Tokyo HY-POWER HL-45 Solution]] == | == [[The Tokyo HY-POWER HL-45 Solution]] == | ||
− | This page documents an example of how to add a commercial solid state 45 Watt Amplifier to your HPSDR rig. The HL-45 is a small compact HF and 6 meter amplifier capable of 45 Watts output on all modes. Band switching is manual, but all required low pass filters are included. Because it requires 5 Watts input to drive to full power, detailed construction notes are provided to provide a small preamp between the Penelope and HL-45. | + | This page documents an example of how to add a commercial solid state 45 Watt Amplifier to your HPSDR rig. The HL-45 is a small compact HF and 6 meter amplifier capable of 45 Watts output on all modes. Band switching is manual, but all required low pass filters are included. Because it requires 5 Watts input to drive it to full power, detailed construction notes are provided to provide a small preamp between the Penelope and HL-45. |
− | + | ||
== [[ PowerSDR Keyboard Shortcut List ]] == | == [[ PowerSDR Keyboard Shortcut List ]] == |
Revision as of 01:50, 29 September 2009
FAQ - Frequently Asked Questions
This is a new section started to allow asking and hopefully answering questions about HPSDR.
DOC - Documentation
Hardware Introduction
Software links and introduction to software components.
Links to HPSDR software and resources can be found on the Resource page.
Links to the FPGA programming course by Kirk, KD7IRS -- see the Verilog page.
Quick Startup Guide
Documents to help users get HPSDR setup and working. Includes firmware upload instructions.
Support documentation
Documents for user interested in building boards can be found on the Support page.
DOWNLOADS - Firmware and Software
Links to current firmware and software available.
SYSTEM INTEGRATION
This section contains information relative to "putting the pieces together".
A complete HPSDR transceiver
This page provides an example of how to build your own transceiver using HPSDR components and other available hardware and software. It concludes with test measurements that compare the finished transceiver to other commercially available high end transceivers.
The Antec P183 Solution
This page documents an example of how to build your own transceiver using HPSDR components and other available hardware and software in a traditional a mid-tower PC enclosure. This example system can accommodate all sizes of PC motherboards up to the standard ATX. The system design will also accommodate larger PC power supplies to power RF amplifiers in the 200 - 500 watt range. The large enclosure is configured to provide a HPSDR with maximum performance.
The Tokyo HY-POWER HL-45 Solution
This page documents an example of how to add a commercial solid state 45 Watt Amplifier to your HPSDR rig. The HL-45 is a small compact HF and 6 meter amplifier capable of 45 Watts output on all modes. Band switching is manual, but all required low pass filters are included. Because it requires 5 Watts input to drive it to full power, detailed construction notes are provided to provide a small preamp between the Penelope and HL-45.
PowerSDR Keyboard Shortcut List
This page lists all the known PowerSDR keyboard shortcuts.
Individual Project Wiki Pages
Click on the NAME of the project to get to its page!
ALEXIARES - RF Preselector
Alexiares (or Alex for short) is a set of RF Bandpass filters for use with Mercury or any other SDR.
ANICETUS (Anie) - Preselector
A few designs for narrow band preselectors
ANTENNA SWITCH - by NT-Electronics
An antenna switch for use with Penelope and Mercury when Alex is not used, also has optional low Noise RX Amplifier for 6 meters
ATLAS - Backplane
The Atlas is a passive backplane that all other modules plug into.
CYCLOPS - Spectrum Analyzer
Cyclops is a 0-1 GHz spectrum analyzer with tracking generator support.
DEMETER - Power Supply
EPIMETHEUS - General Purpose I/O
Epi is a general purpose I/O board for the Atlas bus and includes relays, open collectors, IF switching, etc.
EXCALIBUR - Clock Reference board
GIBRALTAR - GPS-disciplined Frequency Standard
Gibraltar is a GPS-disciplined frequency standard board.
HELIOS - Helios Small Transmitting Loop Antenna and Controller
HERMES - A DUC/DDC Transceiver.
HORTON - Receiver Module
A receiver module integrating the Janus ADC with a QSD on a board for a version of the HPSDR RX board.
JANUS - ADC/DAC Board
The Janus module is a very high performance, dual, full duplex, A/D and D/A converter board.
KISS Konsole - Learning SDR Console
The KISS Konsole is a software project to provide a straightforward, well-commented User Interface to Mercury and other modules.
LPU - Simple Linear Power Unit
The LPU unit takes power from a regulated power supply and steps it to the input needed by Atlas
MAGISTER - USB 2.0 to Atlas Bus Interface
The Magister module is an alternative to OZY.
MERCURY - 0-55 MHz Direct Sampling Receiver
Perhaps the most exciting of all modules, Mercury will enable direct sampling of the 0-55 MHz spectrum.
ODYSSEY - Low Power Handheld SDR
Odyssey includes a low power SDR based on the QSD, QSE, and a dsPIC33 as the basic radio core.
OZY - HPSDR Host Interface & Control
The OZY module is an FPGA based interface controller card providing input and output connections to the real world.
OZYII - (AussieII) - A high speed PC interface.
PANDORA - Enclosure
PENELOPE - Companion Exciter to Mercury
A 1/2 watt DUC(k).
PENNYWHISTLE - 20 Watt RF Power Ampilfier
The PennyWhistle takes the RF out put of Penelope and ampilifes it to approximately 20 watts.
PHOENIX - QSD/QSE Receiver/Transmitter Module
QSD based HF Receiver, a QSE based HF Exciter and a supporting synthesizer.
PINOCCHIO - Extender Card
Pinocchio is an extender card to allow measurements and troubleshooting of an active card in an ATLAS backplane.
PROTEUS - Prototyping Board
This is the planned prototyping board.
SASQUATCH - DSP back-end
The Sasquatch board is a hardware DSP back-end intended for use by constructors who would like to operate stand-alone rather than attached to a PC.
THOR - High Efficiency HF Power Amplifier
Thor is a high efficiency HF power amplifier using Envelope Elimination and Restoration (ERR) techniques.
Board Designer's Resources
ANCILLARY - Additional "stuff" of interest to HPSDR
Some stuff like Norton Amplifier, FPGA VHDL/Verilog ...